oletrucks
[Top] [All Lists]

Re: [oletrucks] Ad Frame

To: Bob Keeland <Bob_Keeland@usgs.gov>
Subject: Re: [oletrucks] Ad Frame
From: ADvent@thuntek.net
Date: Wed, 09 Feb 2000 16:56:58 -0700
This is just an idea, but if you go to 5 bolt hubs, you might be able to use
Eldorado wheels to move them in a bit. The bolting flange on those wheels will 
set
the wheels in about 3 inches.
new mexico jim
51 two ton dump
50 ½ ton

Bob Keeland wrote:

>         Craig,
>
>         You said:
>         > Actually FOUND one in Hempstead TX, but it wasn't for sale...
>         > Marshall's Antique Cars had one on a 48. At least I got to see how 
>it
>         > all works. BTW, they had a BUNCH of old trucks, mostly Apaches. 
>Sadly,
>         > when I looked closely, they all LOOKED nice, but were 'restorations'
>         > of the "shiny paint and new seats" variety; the 48 had a pretty bad
>         > paint job, and the motor and tranny were dripping, rust all over the
>         > frame, etc. For the $6,000-$20,000 they were asking for these cars, 
>I
>         > expect them to at LEAST replace the pan seal and steamclean the 
>motor.
>
>                 I have seen Marshall's Antique Cars but never stopped as SWMBO
>         was along and is not really into old trucks at all.  I guess that 
>there
>         is no real reason to stop now.
>
>         > A shop in Paige, TX had a nasty but restorable 50 panel and 50 or 51
>         > 1/2ton... didn't ask the price. Nearby, there was a completely
>         > decrepit 1/2 ton by the roadside, but there is nothing really left 
>but
>         > a frame and cab.
>
>                 Did the below listed 1/2 ton 'frame and cab' have running 
>gear?
>         I'm looking for a 1/2 ton frame with running gear to sit my 51 1/2 
>ton 5
>         window cab onto.  It is currently sitting poorly on a bent 83 
>Silverado
>         frame and the tires are too close to the outer part of the wheel 
>wells.
>         I have a '54 3/4 ton frame but want disk brakes up front and cannot 
>find
>         a source of a conversion kit for a 3/4 ton front axle (nor does anyone
>         carry a MII IFS for a 3/4 ton).
>
>                 I'll be driving through Paige early next month and might have 
>to
>         stop if it looks like a possibility.  It would be nice to actually 
>start
>         working on restoring my truck instead of just dreaming about it.
>
>         BobK
>         '51 AD 5 window
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>