Jeff,
Check out the Chassis Engineering motor mounts. Their weld or bolt in,
whichever you prefer. I already had my frame boxed in when I installed mine
so they had to be trimmed a little on the back side but they look like
something that could have been original side motor mounts unlike the bent
pipe looking things. I'm very happy with them both mechanically and
cosmetically.
Jeff Davis
'51 custom
>From: J & M Street <jmstreet@earthlink.net>
>Reply-To: J & M Street <jmstreet@earthlink.net>
>To: oletrucks@autox.team.net
>Subject: [oletrucks] Which motor mounts to use in TF
>Date: Tue, 30 Nov 1999 22:08:35 -0800
>
>Hi folks, I'm installing a small block 350 engine in my '55-2 which has
>a must. II front end installed and the frame has been boxed. I'm
>wondering which motor mounts to use. It has been suggested that I use
>the weld in tube cross member type but I'm not sure if it would fit. Any
>suggestions? Thanks. Jeff
>
>Jeff Street- Seattle WA. (what's left of it)
>'55-2 short/step "Street's rod project"
>
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|