Tom,
Quoting from my Chevrolet Accessories Installation Manual on Fog Lamps
(pn 986524):
"Locate two holes in stone guard by measuring from the
centerline of the truck 16 1/2 inches to the outer ends of the stone
guard. Measure 1 7/8 inches from the front edge of the stone guard and
scribe the centers with the 16 1/2 inch measurement. Center punch and
drill two 13/32 inch holes in stone guard."
Hope this helps.
Jeff Nelson
Paducah, KY
> ----------
> From: TomGreer@aol.com[SMTP:TomGreer@aol.com]
> Sent: Saturday, June 19, 1999 12:41 AM
> To: jnelson@paducah.k12.ky.us
> Subject: Re: [oletrucks] auxiliary fog lights
>
> In a message dated 6/17/99 6:18:47 AM Pacific Daylight Time,
> jnelson@paducah.k12.ky.us writes:
>
> << Tom,
> Several of the oletruck vendors (I bought mine from Chevs of the 40s)
> carry an accessory installation instruction book that shows how all
> of
> the accessories available for your model truck are installed. I don't
> have mine with me, but I believe that the fog lamps were installed on
> the front apron. I'll check my book this evening and email you the
> mounting details tomorrow.
>
> Jeff Nelson
> 1953 3600 (in pieces all over the shop)
> Paducah, KY >>
>
> Jeff,
>
> Thanks for the info.. I think I'll either make brackets drill them
> into the
> apron - both will look fine and will certainly add to my "night
> vision"...
>
> regards,
>
> Tom
> '49 3100
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|