Center terminal should be to dash switch. Check center to each side in both
positions hi/low with ohm meter, should tell you. Also wire should be #12.
Hope this is of some help.
Don
48 American 3/4 and 51 Canadian 1/2
----- Original Message -----
From: <MPHUDAK@aol.com>
To: <oletrucks@autox.team.net>
Sent: Sunday, February 21, 1999 12:45 AM
Subject: [oletrucks] Wiring harness
>I was starting to rewire my newly acquired 54, actually just gutting the
old
>wiring and got the headlights done, when it hit me to check my build manual
>for a wiring diagram. Then this is where my problem came from. First off
my
>wiring harness is from golden state, and so are the reproduction rights for
>the build manual. Well the instructions are saying to wire the floor
high/low
>switch one way and the manual is saying to wire it another. I haven't
looked
>any further on any other switches to see if this plague as spread. But
which
>one do I follow. The problem is one says the middle is the high and the
other
>is saying the middle is the constant from the light on/off switch. Has
anyone
>else installed a GS harness. I will comment that the harness looks great
but
>there are some major differences from the original, such being the head
light
>plugs. Thanks in advance.
>
>Hudak
>2-54 3100's
>57 3100
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
|