Are the tapped holes the same? Install the flex hose into the lower
one and the bleed screw into the upper one.
Eric Russell
Mebane, NC
http://home.mebtel.net/~ejrussell
----- Original Message -----
> I just went through my clutch system - had to replace the slave
> because
> the bleed nipple snapped off rather than turning :-(. With the new
> slave it just wouldn't bleed successfully. I blamed the master and
> replaced it - still wouldn't bleed right. Until I turned my brain
> on
> and noticed that the bleed nipple is at the bottom of the slave, so
> any
> air in the slave cannot get out!! Removed the two bolts holding the
> slave on, tipped it so the bleed nipple was uppermost, bled a nice
> load
> of air out, re-fit slave, all is fine now!! Spent 50-odd quid
> replacing
> a M/C that was probably perfectly OK :-(.
>
> I guess most people out there already know this, but I thought I'd
> mention it in case anyone didn't!
>
> Richard & Sammy
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|