mgs
[Top] [All Lists]

Re: [Mgs] 1972 MG Midget wiring question

To: "Max Heim" <max_heim@sbcglobal.net>,
Subject: Re: [Mgs] 1972 MG Midget wiring question
From: "Dodd, Kelvin" <doddk@mossmotors.com>
Date: Fri, 8 Jun 2007 18:23:23 -0700

Max may have it. When the hazard switch is on and the lamps flashing
check to make sure they are all bright. All four lamps may be enough to
trigger the hazard flasher unit, but two lamps with poor grounds may
cause problems for the TS flasher. 

It could also be the hazard switch. In the OFF position it connects the
TS circuit to the TS flasher feed. If the switch contacts are poor, the
hazards could be working fine, but the TS can have problems. 

Try snapping the Hazard switch on and off a few times. It is self wiping
and may clean up. 

If this doesn't work, it's going to be the slow slog of tracking bad
connections with a voltmeter. Not easy as you have some power, but just
not enough to get the TS flasher working correctly.

Good luck.


Kelvin Dodd 


> -----Original Message-----
> From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net]
On
> Behalf Of Max Heim
> Sent: Friday, June 08, 2007 6:02 PM
> To: MG List
> Subject: Re: [Mgs] 1972 MG Midget wiring question
> 
> Bad ground at the lamps?
> 
> Mine are getting slower and more hesitant to switch on. Time for the
> annual
> cleanup...
> 
> 
> --
> 
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the primer red one with chrome wires
> 
> 
> on 6/8/07 5:51 PM, Rabeys@aol.com at Rabeys@aol.com wrote:
> 
> > Can't seem to get my signals to work.  The hazard switch works and
all
> the
> > lights blink, but when I try left and right, nothing.  I checked
every
> ground
> > I can think of and cleaned the connections.  I just changed the
relay
> and it
> > worked for a short time, but only  the right signal.  The  right
would
> blink,
> > but it seemed slow.  The left didn't blink at all  initially, but
the
> lights
> > came on and stayed on.  Every so often it would  blink, about once
every
> 10
> > seconds or something weird like that.  Now  neither works.  I'm at a
> loss.
> > I'm
> > not sure if its related, but the  washer switch isnt working either.
> The
> > signal switch is pretty new and all  connections look great.  I even
> tried a
> > different switch from my parts  car.  Everything worked except the
turn
> > signals
> > again.  Seems to  coincidental.  I'm sure its something simple.  Any
> ideas?

_______________________________________________

Edit your replies

Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs

<Prev in Thread] Current Thread [Next in Thread>