Re: I need to use/borrow a good bore guage]

[Charles & Peggy Robinson <ccrobins@ktc.com>]

   The fact that a guy has machined a lot of cranks doesn't make him a 
expert engine builder.  OTOH, maybe he is....

   I think I'd ask around among the LBC racing fraternity.

   Cheers,

    CR





Larry Colen wrote:

> You make a good point. I'm not an expert either, that's why I was
> taking the advice of someone who machines cranks for a living. The
> clearances he gave aren't a lot smaller than stock, but his tolerances
> are a lot tighter:
>      Nominal  Armando
> Rods 1.9-3.9  1.5-1.8
> Main 1.3-5.5  2.0-2.2