Folks I need to buy the socket that will allow me to remove the nut that
holds the flange on the back of the transmission. Anyone know the size? Is it
'normal' or reverse threaded?
I'm putting in new U-Joints which has gone well except that the dpo put a
bit more ummpf on the fittings then necessary. Two of the studs are stripped
and
deformed so I cut them out with the handy dremel. I have a new set of
proper hardware, I just need to craw under there and wrench the flange off.
Thanks!
Alex
Alex Greenberg
1976 MGB - Fair weather daily driver ( Junior ) GHN5UC402027G
1996 Subaru Legacy LS - reliable great little car
1974 Ducati 750 GT - exquisitely beautiful motorcycle
|