Yep, I'm with you, JFDI! No funny noises, at least not from the rear end,
no pun intended;^)
Thanks again.
Gordie
>
> Well, it pre-loads the pinion bearing. So if it were
> over-crushed I'd expect either pinion bearing noise
> immediately (which is perhaps more likely with an
> under-loaded pinion bearing allowing too much lash), or maybe
> after a while if the bearing is being over-loaded. If it
> isn't making any funny noises then I'd JFDI ;o) If it *is*
> making funny noises then it implies the pinion and ring gear
> aren't in correct relationship, which can cause damage to
> much of the diff.
>
> PaulH.
>
> ----- Original Message -----
> > Anyone know what the symptoms would be if you tightened too far and
> crushed
> > the collapsible spacer?
|