Dick, It's not metric. It's 7/16-20. 1/2 inch long socket head set screws
are what I used. Let me know if you can't source them locally -- I have
enough for two more heads. They also have a gasoline etc. resistant thread
sealer on them.
Larry Daniels
79 MGB LE
72 Midget
60 Bugeye
"You only need two tools: WD-40 and Duct Tape. If it
doesn't move and should, use the WD-40. If it
shouldn't move and does, use the duct tape."
----- Original Message -----
From: "RICHARD BOES" <csrb7007@msn.com>
To: "mgs" <mgs@autox.team.net>
Sent: Sunday, September 11, 2005 8:05 PM
Subject: Blocking Air Rail Ports in Head
What could I use to block the air rail ports in the cylinder head. Is there
a
metric pipe plug that'll work?
Thanks,
Dick Boes
'79B project
|