Is there any known issue with Moss supplied V8 bushes not fitting on the
fulcrum pin? Out of a set of 4 bushes, only two would slide over the end
of the pin...
Thinking the pin may have a burr or other damage, I removed it and
inspected it - it's completely clean, and free of burrs, dents, dings,
etc... I cleaned it to make sure there was no built up grease, etc. Then
I thought that maybe I had somehow damaged the inner steel tube of the
bush when I pressed it in place, but as mentioned, just taking the new
bushes and test fitting them to the pin, only 2 of the 4 would slide on...
Are all V8 bushes the same, or are there different sizes?
--
Marc
|