Good Morning -
Finally getting around to replacing the bushings in the front end of my
'80 mgb. Should I figure on replacing the seals, washers, etc on the
lower trunnions? Looks like Moss has a lower trunnion kit with all the
parts. I haven't done this in a few years, can't remember if I need to
disassemble that stuff to change the bushings... I think it's all gotta
come apart, don't really see how else you could do it...
Looks like the later B's used more mounting pads on the crossmember -
can anyone confirm exactly whats required?
I'm planning on using the V8 bushes - do they need to be pressed in? If
so, will a large bench vise suffice?
What is the collective wisdom on replacing the (25 year old) sway bar
links while it's all apart? Last time I replaced the bushes in a sway
bar, it was horrible! I had to grind them out with a dremel tool... took
quite a lot of effort!
Hoping to order parts today to have them in time for the weekend! It's
been a long time since I've had much opportunity to spend time in the
garage!
Thanks for any advice
-Marc
|