Hi Listers,
I have been reading through the archives and haven't found the problem I am
having. I replaced all (3) hoses, (the rear outer casing was completely split,
the inner casing seemed okay). Anyway, I was able to bleed (3) of the brakes
but on the right rear I can't get anything (air or fluid) to come out. The
only other thing I did was replace that wheel's bleeder screw. I even took the
entire bleeder screw out and tried to bleed the brake and nothing happened. It
acts like there is something plugged up! When replacing the bleeder screw if I
got a little greasy dirt that was around the hole accidentally pushed in the
bleeder screw hole could that cause this problem? Looking for ideas.
Thanks in Advance
Randy Widman
Red '79 B
|