Greg,
It's hard to envision all of the parts, but I believe they go in the
following order from front to rear of the dash:
The barrel (the part with the red or black plug faces)
The plastic ring (to insulate them from the dash panel
Fiber washer (again to insulate them from the dash panel
Cardboard guard (to electrically separate the plugs)
Brass washer
Nut
You'll want to ground one of the plugs (which depends upon whether you are
running positive ground as original or negative ground). The other should be
connected to the hot side of the ammeter (the side that is connected to the
battery at the starter switch.
Cheers,
Lew Palmer
-----Original Message-----
From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net] On Behalf
Of GJARM@aol.com
Sent: Sunday, May 16, 2004 11:52 AM
To: mgs@autox.team.net
Subject: MGTD Accessory Plug Socket Set
I'm finishing up a 20 year restoration project on my MGTD and need some
help.
Does anyone know the proper arrangement of the various washers, spacers,
and
nuts of the accessory plugs? I bought a set from Moss but don't know how
they are supposed to be assembled. The parts consist of the barrel, plastic
ring, black cardboard guard, fiber washer, brass washer, and two round
threaded
nuts. I'm confused! Please send reply to my email address: gjarm@aol.com
Greg Armstrong
Oshkosh, WI
|