OK, I'm getting ready to get started on the rocker repairs. Unless I run
into major issues, what kind of time am I looking at for doing each side?
Door sill in great, I am replacing the inner sill (central membrane), the
rocker panel (outer sill), and the horizontal member (sill base/castle
section). Any hints/tricks? I've been going over a few websites that go
throught it in pretty good detail http://www.mgbnet.org/resto/sills.htm but
nobody discusses the time involved. I'm guessing 1/2 to 1 day per side...
I'm assuming my wire feed (not mig) welder is good enough?
Regards,
TJ
|