Which model brake cylinder are you working with? Inner workings differ.
You can get started with disassembly by removing the spring clip just
inside the bore at the piston end. Some then have a plastic spacer that
may come out, but may have to be drilled for a screw that is used to pull
it out. After that, you just remove pieces and keep them in order.
Best to have the new kit on hand so you can check off what you remove
against what you should be retaining and replacing from the kit.
Bob
On Wed, 17 Mar 2004 19:51:33 -0500 "Evan Laub" <Laub25@hotmail.com>
writes:
> i was going to rebuild the break cylinder but don't know how to get
> it apart, help please thanks
|