If its too low when inverted (i.e. too high when fitted) you can put washers
under the valve. If the other way perhaps shave plastic off the float ...
then fit washes when you found you have gone too far ...
----- Original Message -----
From: <Menno.Meijer@ict.nl>
To: <mgs@autox.team.net>
Sent: Tuesday, July 01, 2003 1:59 PM
Subject: Different SU HS4 floats?
> How am I supposed
> to adjust the level in case of the "plastic" float?
> (There's no metal to bend) Or are these floats always
> correct? (I'm affraid not)
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|