mgs
[Top] [All Lists]

Re: questions about engine rebuild

To: mgs@autox.team.net
Subject: Re: questions about engine rebuild
From: WSpohn4@aol.com
Date: Sun, 22 Jun 2003 11:28:07 EDT
In a message dated 6/22/03 5:58:29 AM Pacific Daylight Time, 
owner-mgs-digest@autox.team.net writes:


> 1. I am planning to have the engine bored to 1950cc. What are the pluses
> and minus (if any) of the Moss 1950 piston set or would an alternative set
> be suggested.
>     What other mods are useful?
> 

I'm not sure which pistons they are using at Moss these days, but if they are 
the Lotus pistons that require shaving the block by a considerable amount, 
I'd give them a pass and buy decent custom pistons that have the correct 
compression height.

> 2. Does one gain from a standard cam improvement in the 45-75mph  range
> with the Moss "Fast Street Camshaft"?
> 

Very little unless the head is also modified.

> 3. Can one describe the significance of the cross-flow head advertised in
> Moss vs the standard for only street driving? (Bit pricey but I can ask!)
> 

Bit more torque, and you can run a bit more compression on the same gas. I 
agree - expensive for street use, but I like the results.

> 4. I don't have an oil cooler on my machine and I am located in the
> mid-Atlantic states. Is one warranted?
> 


Yes!!

> 5. Other than cleaned up, should I have anything done to the flywheel
> (lighten?, replace with the alloy flywheel?

Alloy flywheel is too expensive for what you get. If you are having the 
engine balanced, have them lighten the stock flywheel a bit.


> 
> 6. I do need to replace the distributor...suggestions?
> 


No, and DO NOT get sucked in by those sorry-assed Mallory dual point units. 
Just make sure that the stock one is in top working order, and have it 
reconditioned if it needs it.

> 
> In case you couldn't tell, I really don't know the automotive theory
> behind what I'm doing or why, but I must say, doing this is the most
> fun I've had since I made my last plastic model airplane 41 years ago.


Don't expect big improvements on the street with mild modification. I dare 
say you could spend a few thousand dollars and get maybe 5 bhp - you be the 
judge as to whether that is money well spent. At least I didn't see a Weber on 
your list (another of the big money wasters, in the absence of head mods - the 
only thing sadder than people spending $700 for a sidedraft conversion and 
expecting more than the 3 bhp at top end is someone spending $500 on that 
worthless 
DGV conversion and expecting anything at all!)

Bill

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>