-----Original Message-----
Okay, I'm ready to change the oil in my rear axle (68 BGT) for the first
time, and I can't figure what tool to remove the drain plug or full/level
plug with. To large for a 3/8" drive, too small for a 1/2" drive. What do
you use?
----------------------------
Go to any hardware store and buy the following 3/8" pipe fittings: 6" nipple
(or any length pipe, really), 90 degree elbow, plug. Put it all together
nice and tight and you have the perfect rear end drain plug wrench for a
few bucks. The reason this works is that the male square drive on the plug
is the same dimension as the female drive on the drain plug.
Dean
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|