Thanks for all the responses. I am pleased to see that I managed to
start a thread of respectable length. If my rotors turn out to be above
the minimum, I will probably leave them alone for now. Unlike the rear
bearings, it doesn't appear to require undoing a ton of work to get to
them later.
Jim Feyrer
68 MGB
>>>Jim,
>>> In the workshop manual somewhere is minimum thickness
>>>allowed for the
>>>rotors.
>>>
>>>
>>
>>I have been looking for this spec. and have not found it in any workshop
>>manuals. If anyone has, please let me know. New rotors supplied by Brembo
>>are imprinted with "Min thickness 7.6mm or .30 inchs" so I would think
>>that is a good spec. to go with.
>>
>>
>>Kelvin.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|