It looks like3 I'm the only one using a 1-3/8. Again, I stand corrected.
It's possible that I've taken mine off with a sloppy-fit socket. But it
works.
Regards,
Lew Palmer
-----Original Message-----
From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net] On
Behalf Of Telewest (PH)
Sent: Thursday, December 05, 2002 8:35 AM
To: Chris; mgs@autox.team.net
Subject: Re: help
1 5/16" AF, you'll need a socket. I have found an off-the-shelf 1/2"
drive
non-impact fits in the hub, others have said that the 3/4" drive is too
big,
mine is 1.73" outside diameter.
----- Original Message -----
From: "Chris" <slimyrat@hotmail.com>
To: <mgs@autox.team.net>
Sent: Thursday, December 05, 2002 1:39 PM
Subject: help
> does anyone know offhand what size spanner to use on the castellated
nut
> holding the rear wheel bearings onto a tube axle?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|