Yes, it is 1-5/16", and also the Snap-On 1/2" drive socket fits it. You need
something with a thin wall.
David
-----------------------------
----- Original Message -----
From: <ATWEDITOR@aol.com>
To: <mgs@autox.team.net>
Sent: Thursday, December 05, 2002 8:16 AM
Subject: Re: help
> In a message dated 12/5/02 9:39:30 AM, slimyrat@hotmail.com writes:
>
> << does anyone know offhand what size spanner to use on the castellated
nut
> holding the rear wheel bearings onto a tube axle? >>
>
> I am fairly certain that it is 1 5/16". Now, the part that I am certain
> about is that most standard sockets of that size are too wide to get into
the
> hub, having gone through two regular sockets before learning exactly what
to
> get. Hint--not Craftsman.
> I had to order an SK #40142 1/2in drive socket from an on-line tool
company.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|