1 1/8 SK socket
----- Original Message -----
From: "Andrew B. Lundgren" <lundgren@byu.net>
To: <mgs@autox.team.net>
Sent: Tuesday, August 20, 2002 1:34 PM
Subject: Size of the front wire wheel hub nut...
> To my surprise I found that the nut with the clevis pin holding the front
hub on is not the
>
> same as the one on the back. (I am doing th drivers side first, so I
don't know what the
>
> otherside has.)
>
> Is this normal?
>
> If so, can someone tell me what size the front nut is? (I need to buy big
socket
> on my way home from work, but don't know what size...)
>
> I looked in my factory manual, it just says to take it off. I got the
back off with no
> problem. 1-5/16" IIRC. My porter says about the same... (I will try Moss
next, didn't
> think of that!)
>
>
> (Thank goodness for air tools, without them I was cranking the engine over
with my ratchet on the
> nut.)
>
>
>
> --
> Andrew Lundgren
> lundgren
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|