To my surprise I found that the nut with the clevis pin holding the front hub
on is not the
same as the one on the back. (I am doing th drivers side first, so I don't
know what the
otherside has.)
Is this normal?
If so, can someone tell me what size the front nut is? (I need to buy big socket
on my way home from work, but don't know what size...)
I looked in my factory manual, it just says to take it off. I got the back off
with no
problem. 1-5/16" IIRC. My porter says about the same... (I will try Moss
next, didn't
think of that!)
(Thank goodness for air tools, without them I was cranking the engine over with
my ratchet on the
nut.)
--
Andrew Lundgren
lundgren@byu.net
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|