What you don't want is a distributor with the clap.
If you *do* find that rotating it 180 degrees allows it to seat properly you
will also need to rotate the plug leads on the cap 180 degrees before it
runs again. If not either there is something lying in the grove in the
drive gear or it or the drive dog are heavily burred.
----- Original Message -----
From: <GMGoodman@aol.com>
To: <mgs@autox.team.net>
Sent: Wednesday, August 07, 2002 10:47 PM
Subject: distributor
> 72' mgb....why won't my distibutor drop all the way into the
block.....when
> it does...and timed' runs great....but lifts out of block and then engine
> dies because dist. shaft is not turning...can't get it to drop in far
enogh
> to tighten down with clap j goodman
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|