Make sure you are not trying to put it in 180 degrees out of alignment.
Before you say it isn't possible, loosen it up, rotate it and see if
it drops the rest of the way in...
GMGoodman@aol.com wrote:
> 72' mgb....why won't my distibutor drop all the way into the block.....when
> it does...and timed' runs great....but lifts out of block and then engine
> dies because dist. shaft is not turning...can't get it to drop in far enogh
> to tighten down with clap j goodman
--
Andrew Lundgren
lundgren@byu.net
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|