Greyson,
Yes, I'm saying the way your car is set up is wrong. Is this a "factory
mistake"? Who knows? Did you buy the car new and know that the cylinder has
never been changed? If so, then I guess it would be. If not, then there
exists a possibility that someone has changed (and installed incorrectly)
the slave cylinder in the last thirty-odd years.
Try a different method of bleeding if you like. Or, to save time, move the
bleed nipple to where it can reach the trapped air..........
Lawrie
British Sportscar Center
----- Original Message -----
From: "Greyson Crowe" <nismoracerxe@icqmail.com>
To: <mgs@autox.team.net>
Sent: Monday, June 17, 2002 12:24 PM
Subject: Re: Well the clutch hose is fitted....no clutch pressure??
> well...My clutch hose goes into the side hole, and the bleeder is on the
front hole. And to double check, your saying this is wrong? This is how
the car was bought...was this a factory mistake? If all else fails, I may
try the "different bleed" approach. Keep them comments a comin!
> Thanx,
> Greyson
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|