Most definitely use a 6-point socket! In fact, I don't use 12-point sockets
in any situation requiring torque specs (to tighten), or application of
excessive force (to remove). Good luck!
on 11/24/01 5:07 PM, Dan DiBiase at d_dibiase@yahoo.com wrote:
> 3/4 fit but the 19 mm seemed just a bit tighter... I am going to pick up a
> 6 point socket in each along with an impact wrench this week.
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|