Hello all,
After getting the new rear axle in, and finally getting the old plug
out, I thought I was in the home stretch. I went to bleed the brakes,
and nothing comes out of the rear, even with a Mityvac. Haynes says to
loosen the Pressure Failure Switch on the bottom of the master
cylinder. Only problem is, there is no switch, just a bolt, which does
come out. I checked all the lines except the master cylinder to under
the car line, and I don't think I have any blockages (plus the brakes
seemed to work before). Is the PDWA necessary to bleeding? Do I need
to rework my master cylinder? Any advice is welcome.
Thank you
Mike Jose
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|