Got spark to all four plugs on my TD! First two cylinders are still
not firing, but the motor is turning over and idles pretty good. When
I tried to drive the car it would not go with any real speed or
strength. Got the TD back in the garage and while running I took a
pair of pliers and pulled the #1 plug wire off, no change in the way
the car idled, put it up to the block and got spark and a small shock
to me. Same drill on #2 plug wire with same results. Went to #3 and
#4 did the same thing and the engine about died out when I pulled the
#3 plug wire and then the #4 plug wire.
Should I move over to the carb side now? And see if they are not
getting fuel. We did replace a seal in the front carbs with a jury
rigged seal to replace the one that was leaking.
THANKS!
MIKE R
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|