yep. a ' welded' connection of course would be best.
A crimp is a close as you can get.
After crimping... solder it. :-)
Paul Tegler ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Charley & Peggy Robinson" <ccrobins@ktc.com>
To: "Ptegler" <ptegler@gouldfo.com>
Cc: "Douglas" <mup1dm@surrey.ac.uk>; "mgs"
<mgs@autox.team.net>
Sent: Thursday, March 08, 2001 5:22 PM
Subject: Re: Wiring basics - Oh No! Big point missed!
> Paul,
>
> Back when I worked for the army in the electronic
instrumentation
> field, I ran into a guy who was a tech rep for a company
which sold
> crimp-on connectors and crimping tools therefore. He had
some brochures
> on crimpimg. These missives had it that a quality crimp
involved a
> pressure-weld situation where the metals in the connector
and the wire
> actually intermingled. The claim was that this action
produced the
> lowest possible crimp-joint resistance. The brochures
went on to say
> that because of this, the right connector, crimped at the
right prassure
> for the wire in use was very important. Your post called
that from
> memory. Ring a bell?
>
> Cheers,
>
> CR
|