To: | neilc@apphosting.com, mgs@autox.team.net |
---|---|
Subject: | Re: Wiring basics |
From: | Mgbbob@aol.com |
Date: | Fri, 2 Mar 2001 22:39:34 EST |
Neil, That's what I do when I need to join a couple of wires....solder. Get to a Radio Shack and get some "heat shrink" tubing just larger than the wire size you're looking to join; put it over the wire prior to soldering; clean the wires of all grease and contaminants; solder these wires together then slide the shrink tubing over the joint and hold a match under it until it creates a tight seal. I've had some pretty good luck with repairing "professionally" repaired crimp fitting with Lucas "bullet" connectors. Good luck Bob 66 B RD GHN3L 78708 60 TR3A TS 81398L |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | MG mail, David Deutsch |
---|---|
Next by Date: | fiberglas or weld...that is the question, Mgbbob |
Previous by Thread: | RE: Wiring basics, Garner, Joseph P. |
Next by Thread: | RE: Wiring basics, Duinhoven_Hans |
Indexes: | [Date] [Thread] [Top] [All Lists] |