Try Haynes page 208, Chapter 11 Suspension and steering, Section 13, Front hubs
- description, removal, dismantling and refitting. There's a simpler technique
for refitting the shims, no dial gauge needed, but I can't seem to find its
reference. Listers? There's a good chance that the shims that you take out may
be just right for reassembly. Don't lose 'em.
Michael Jose wrote:
> I have a Haynes and looked, but didn't find it. What page is it on?
> What are the shims for? Shouldn't it just be pulling the old out, putting
> the new in with grease, and tightening to spec?
> Please advise
> I just got the bearings, inner and outer, and seals, anything I missed?
> thanks again.
> Mike Jose
>
Bud Krueger
http://home.ici.net/~bkrueger/
52TD
77MGB
|