In a message dated 24/08/00 12:28:37 PM Pacific Daylight Time,
owner-mgs-digest@autox.team.net writes:
> inally I've found the cause of my non-working horns. There is no
> continuity to ground on my steering column. The steering universal joint
> grounds fine but the threaded/splined end (for the steering wheel) does
> not. It may do so occasionally but most often it doesn't.
> > My idea is to look for an earlier (70-72) indicator switch that has the
> horn contact on its stem. Any comments on that?
Sure - just get a wire with 2 ring connectors on the ends, big enough to go
over the 1/4" (I think) bolts that hold the U joint pinched on the column.
Put one on each side of the joint, and grounded you will be.
Bill
|