Larry,
Could be that you have the idling speed set to high. 750rpm absolute maximum.
Graham
At 08:26 pm 25/7/00 -0400, Larry Macy wrote:
>I have the Midget finally running in good form. However one thing puzzles
>me. After setting the timing, adjusting the Weber, replacing the coil,
>plugs, wires, etc, and finally running the valves, it runs like it is
>supposed to. Except for one thing. It diesels (runs on) after I shutoff
>the ignition. I always thought that was mostly a timing issue. Or a
>mixture adjustment. But I can not seem to get it to stop when I shut the
>key off.
>
>Any clues??
>
>Thanks
>
>Larry
>
>Larry Macy
>78 Midget
>
>Keep your top down and your chin up.
>
>Larry B. Macy, Ph.D.
>macy@bblmail.psycha.upenn.edu
>System Manager/Administrator
>Neuropsychiatry Section
>Department of Psychiatry
>University of Pennsylvania
>3400 Spruce St. - 10 Gates
>Philadelphia, PA 19104
>
> Ask a question and you're a fool for three minutes; do not ask a
>question and you're a fool for the rest of your life.
Graham McCann Rivett, ACT. Australia
gmccann@pcug.org.au
Phone/Fax: +61 2 6288 9055
______________________________________________________________
|