The unit can be opened at one side.
Poor in some alcohol liquid - no not the booz!
Perhaps you can put the complete unit into a little can of alcohol.
Leave it in for a few days, then the piston will have come loose.
You may push it from the center point where the switch sticks in.
Have you an extra switch (I mean only the switch not the hydraulic stuff)
perhaps?
Mine is defect.
Cheers,
Hans
-----Original Message-----
From: cl4rk2@worldnet.att.net [mailto:cl4rk2@worldnet.att.net]
Sent: zaterdag 22 juli 2000 7:57
To: mgs@autox.team.net
Subject: Brake pressure failure assembly
Have '69 BGT: dual line, non-servo brake system.
The shuttle piston inside the brake pressure warning assembly is
frozen. What's the best method to remove this piston (so that I may
install new o-rings)? Any suggestions?
KC
|