MIke:
You may have noticed on the vertical front wall of the rear
ledge there are two "male tabe" for the lift a dot connectors. The
theory is that when you roll back one or both halves you roll it so
underside is inside the roll leaving the lift a dot tabs out...these
connect to the little male tabs on the ledge keeping it tight as you
drive along.
Malcolm in Nova Scotia
Mike Razor wrote:
>
> Time for another dumb question or so!
> What are the two tabs in the middle of the tonneau, with lift-a-dot
> fasteners for?
> Second, the two zippers behind each seat?
> Third, what would a new tonneau be worth? Two came with the car, I
> just repaired and refitted the old one, which is like a new one and I
> don't see any reason to have two.
> Finally, I was told that the two gray tubes are to support the
> tonneau, but I don't have the slide-in mounts for them.
> THANKS!
> Mike R
|