I recently replaced on a 76B, the Z-S carb for a pair of HIF's with the
requisite change in manifolds.
The question is rehooking up the brake vacuum boost. I thought I'd remove
the port from the old manifold and use the same port on one of the unused
stoppered holes in the replacement intake manifold (assuming I can get it
off after 25 years).
Is that what is done for this modification? If not, what?
TIA,
Bill
**********************************************************************
Dr. Bill Saidel
Assoc. Prof. Vocal phone (609) 225-6336
Department of Biology FAX (609) 225-6312
Science Building email: saidel@crab.rutgers.edu
315 Penn St.
Rutgers, the State University of New Jersey
Camden, NJ 08102 -1411
http://crab.rutgers.edu/~saidel/saidel.html
|