I know this sounds stupid but I video taped under my dash before I started
labelling and yanking wires. It was handy to come back to the video and see
how it used to be. I thought it would be an easy task to replace the dash
with a wooden dash. It was not easy. Also, make sure to label each wire
etc...
Good luck!
Mike R
Edwin Vaughan wrote:
> Hello everyone,
>
> Are there any special tricks that I need to know in order to remove my
> dash?? Got to put in a dash wiring harness and it was recommended that I
> remove the dash. I looked under the dash and came to that same conclusion.
>
> TIA,
>
> Edwin
> '77 B
>
> ________________________________________
> / \
> | "I try to think but nuthin' happens" |
> | -- Curly Howard (the stooge) |
> | |
> | The MG Filling Station |
> | http://www.auburn.edu/~vaughme |
> \________________________________________/
|