As a matter of fact this was dicussed here not long ago and the it was concluder
that the coil was not for electronics as they required the ballast resistor for
proper operation, I have a crane 700 in the box right here and it requires a
ballest resistor in line before the coil. Carl E.
teds wrote:
> who told you that ? it works fine for EI's, I used it with a pertronix and a
> MSD system. just remove the ballast resistor and the ballast wire. make sure
> you get 12+- volts at the + terminal with the ignition on, not 8 or 9, which
> would indicate a resistor in there.
>
> ted stowe
> -----Original Message-----
> From: Carl Elliott <grunt2@adelphia.net>
> To: Steve Shoyer <steve@shoyer.com>
> Cc: mgs@autox.team.net <mgs@autox.team.net>
> Date: Sunday, January 24, 1999 8:12 AM
> Subject: Re: Lucas Sport Coil on 1980 MGB
>
> >The Lucas Sport coil is for Points, Not Electronic Ignitions.
> >Made the mistake and now have a brand new coil I don't need,Carl E.
> >
> >Steve Shoyer wrote:
> >
> >> Before buying and installing a Lucas sports coil, I want to make sure
> that
> >> I know what I need to do to get it to work. If I understand the
> directions
> >> on Skye's web page, I need to:
> >>
> >> 1) Swap the coils
> >> 2) Run a (white) wire to the + terminal on the new coil
> >> 3) Open the spark plug gap
> >>
> >> Has anyone done this conversion and have any specifics to offer? I'm
> >> wondering about the size (diameter) for the new white wire, where it
> >> connects, how wide to open the spark plugs, and anything else that might
> be
> >> important. Did the new coil make much of a difference?
> >>
> >> Thanks in advance.
> >>
> >> --Steve (1980 MGB)
> >
> >
|