Eric,
Your email address makes me think that you have a 77B w/HS4's. Is that
correct? That's the setup that I have and I just finished reinstalling the
carbs after having Lawrie work his magic on them. I'd be happy to send you some
digital images of the choke and throttle linkages if you'd like. Let me know.
A few brief comments: 1) the choke cable comes up from under the linkage and
it's the sheath that does the actuating, not the inner cable. 2) a picture would
be easier. 3) two for the throttles, one for the choke. 4) not with HS4's. 5) I
just installed a Falcon s/s system, it's clamped together. 6) depends, the end
ones are shorter than the others. Mine are all in place, so I can't help you
there.
Bud Krueger
52TD
77MGB x2
Erik Brzoska wrote:
> Can anyone who has HS4 carbs on their B, go out to the garage and take a
> look at them and give me some info on the following questions, please?
>
> 1. Where does the choke cable connect and how is it routed to the carbs?
> Is it connected to the operating rod nearest the rear carb or front?
>
> 2. What is the choke cable attached with?
>
> 3. How many springs are attached to the choke op. rod, and how many to
> the accelerator op. rod?
>
> 4. Do you have an induction heater betwen the heat shield and the intake
> manifold
>
> 5. Are your muffler sections welded together or are they flanged
> fittings that bolt together?
>
> 6. Final question; what thread pitch and total length are the exhaust
> manifold studs?
>
> TIA
> Erik.
|