mgs
[Top] [All Lists]

Re: Fuel Pump Orientation 77MGB

To: Paul Hunt <paul.hunt1@virgin.net>
Subject: Re: Fuel Pump Orientation 77MGB
From: Bud Krueger <bkrueger@ici.net>
Date: Sun, 10 Jan 1999 17:41:55 -0800
Paul,

     It appears that the word 'top' is used to in conjuction with a few other
words to indicate which of the ports is the outlet.  Your reference to both
ports facing forward is a tough one for me to handle since the setup on the 77
(the big donut) can only have them on the right or left.  I guess the action of
the pump is such that there is no preferred orintation.  Thanks for the
response.

Bud Krueger

Paul Hunt wrote:

> My 73 has both ports facing forward.  On my spare pump I note that 'TOP' is
> embossed into the casting by the ports in such a postion that one might
> easily assume that the ports should face upwards.  However the opposite side
> of the same casting (i.e. either side of the 'delivery flow smoothing device
> cover') is also embossed 'TOP', meaning that if one 'TOP' faced upwards, the
> other would be facing downwards.  I can only conclude that said 'delivery
> smoothing device cover' should be at the top i.e. both ports facing
> forwards.
>
> Which was where I came in.
>
> (Shades of the Naval shells where "the bottom of the shell shall be clearly
> marked 'TOP'")
>
> PaulH.
>
> -----Original Message-----
> From: ccrobins <ccrobins@ktc.com>
> To: Bud Krueger <bkrueger@ici.net>
> Cc: MG List <mgs@autox.team.net>
> Date: 10 January 1999 06:59
> Subject: Re: Fuel Pump Orientation 77MGB
>
> >Bud,
> >
> >  If you look at the pump it says "Top" by the outlet side.  I asked the
> >same question when I took the Midget pump out of mine and installed the
> >B pump.  No one answered me definitvely so I looked under a lot of Bs.
> >;^)  Anyhoo, I installed mine with the outlet on top because that's the
> >way it was installed in the Bs that looked original.  Had to do some
> >fancy tubing bending to get the new rigid line from the tank to mate up.
> >A DPO had butchered the old line.
> > Interestingly, the photos in my Porter's, "Guide to Purchase and  DIY
> >Restoration" show the pump in two different orientations.  Go figure.
> >
> >  It work OK in the orientation I described.  Now if I could just get
> >the damned fittings to quit seeping!  Anyone got a neat trick to take
> >care of that?
> >
> >  Charley Robinson
> >  '69 B
> >
> >




<Prev in Thread] Current Thread [Next in Thread>