In a message dated 10/13/98 1:44:40 AM Central Daylight Time,
bwatson@bayflash.stpt.usf.edu writes:
<< I recently burned one of my bearings so badly that I was able to take the
bearings out with a pair of needlenose pliers (they were far from round)
and thus remove the hub. Then I used a Dremmel rotary tool to cut through
the bearing housing that was seized to the spindle, then wack it off with
a large screwdriver and a BFH.
Hope this might give an idea.
*******************************
Berrie C. Watson
Assistant in Campus Computing
USF St. Petersburg Campus
bwatson@bayflash.stpt.usf.edu >>
Berrie,
"Never use force, get a bigger hammer" is what the chief engineer at a radio
station I worked at about 30 years ago used to say. Enjoyed your "BFH".
R. Johnson - Dallas
|