Barnhart, Christopher wrote:
>
> One for the collective wisdom,
>
> What is the correct way to install the inner oil seal collar on the front
> hubs -
> inner chamfer facing "in" (toward the car) or "out" ? When I pulled the
> front
> hubs off to check the wheel bearings each side was installed differently.
> I've looked a several diagrams and still can't seem to figure it out.
> Thanks.
>
> Chris
> 69 MGB
Chris,
There are numbers on the seals. The numbers have to point towards the
engine side of the hub.
Rene
--
Rene and Marion van Maanen If everything seems to be going well,
Netherlands Europe you obviously don't know
what the hell is going on.
(Murphy)
SOHC #252 sohc4@dorje.com Honda CB350F ['74]
Honda CB750K2 ['75]
MG list mgs@autox.team.net MGB GT ['68]
|