Chris.......
The chamfer is supposed to follow the radius of the stub axle as it blends
into the king pin. So, the chamfer faces in towards the car.
Lawrie
-----Original Message-----
From: Barnhart, Christopher <BarnhartC@ioc.army.mil>
To: 'mgs@autox.team.net' <mgs@autox.team.net>
Date: Tuesday, September 29, 1998 11:53 AM
Subject: Front Oil Seal Collar
>One for the collective wisdom,
>
>What is the correct way to install the inner oil seal collar on the front
>hubs -
>inner chamfer facing "in" (toward the car) or "out" ? When I pulled the
>front
>hubs off to check the wheel bearings each side was installed differently.
>I've looked a several diagrams and still can't seem to figure it out.
>Thanks.
>
>Chris
>69 MGB
>
|