Also, the float tube should point straight up!
bdk wrote:
> It should work! Maybe your Unisyncs are defective?
>
> Make sure the float isn't stuck and that the orifice is open both at the
> venturi and at the end of the float tube.
>
> Maybe this is obvious, maybe not- but you took the air cleaners off to do
> this, right? Do your Unisyncs have the foam sealing gasket on the flange?
>
> You should adjust the center part to get the float to approximately
> mid-scale.
>
> The Unisync works just fine on my '71 B/GT.
>
> Good luck,
>
> Brandon K.
>
> Dan Pockrus wrote:
>
> > > When I tried to use the Unisync, I couldn't get the little
> > > plastic float to
> > > move at all. I screwed the air flow gadget in the center of
> > > the Unisync up
> > > and down but no joy at any setting. Anyone have an idea what
> > > I'm doing wrong?
> >
> > I don't think you're doing anything wrong. My feeling is that an
> > SU at idle doesn't suck enough air for the float to move. I had the same
> > problem yesterday with the same result - I gave up.
> >
> > Dan Pockrus
> > '74 CBB
|