It should work! Maybe your Unisyncs are defective?
Make sure the float isn't stuck and that the orifice is open both at the
venturi and at the end of the float tube.
Maybe this is obvious, maybe not- but you took the air cleaners off to do
this, right? Do your Unisyncs have the foam sealing gasket on the flange?
You should adjust the center part to get the float to approximately
mid-scale.
The Unisync works just fine on my '71 B/GT.
Good luck,
Brandon K.
Dan Pockrus wrote:
> > When I tried to use the Unisync, I couldn't get the little
> > plastic float to
> > move at all. I screwed the air flow gadget in the center of
> > the Unisync up
> > and down but no joy at any setting. Anyone have an idea what
> > I'm doing wrong?
>
> I don't think you're doing anything wrong. My feeling is that an
> SU at idle doesn't suck enough air for the float to move. I had the same
> problem yesterday with the same result - I gave up.
>
> Dan Pockrus
> '74 CBB
|