On Wed, 8 Jul 1998 21:32:01 -0500, Harlan Jillson wrote:
>Andrew,
> I've been waiting for someone better in the know to answer you
>on this one today, but so far no takers, so here goes my $0.02.
> One of the changes when the RBB design came along was an
>increase in ride height to meet US Federal standards. I'm not
>sure, but I think it was on the order of 2 inches. As far as I know
>there isn't any reason you can't replace your springs with the RBB
>springs, but you'll probably get an increase in ride height in the rear.
>With no change in front suspension geometry this will probably
>change your handleing characteristics, and you should be aware of
>it.
Now ya tell me! :) I have the drivers side installed already. I am thinking
that with the sag that these
used springs I am installing probably have the ride height shouldn't be that
much higher from new CBB
specs.
Lot of hope and guessing there huh. Wish me luck!
Andrew Lundgren
Lundgren@iname.com
http://www.itwest.net/~lundgren
|