RE: 18V head on pre-18V motor?

["Unger, Larry G" <larry.g.unger@lmco.com>]

Andy Ramm wrote:

> Is it OK to put a pre-18V head on a non 18V motor?
> I assume pushrods and tappets would have to be
> changed, anything else?

Based on the subject line of your message, I assume your asking about
fitting a 18V head to a pre-18v
engine.  In additon to the pushrods and tappets, you
will need to add the cut-outs, for the exhaust valves,
to the block face.

Safety Fast! ... larry.g.unger@lmco.com
'61 MGA 1600 MkII