BILL GLANVILLE wrote:
>
> When I did my MGA's SU's a couple of years ago they came with some brass
> flat washers which were to be used to help approximate the heighth of
> stock needle and seat. This would minimize the amount of bending to the
> float arm needed to set proper height. Just add washers where Grose Jet
> threads in to carb.
I used one of the three included washers and it seems to sit
fine.
I have the later all-plastic SU floats so this is the only way
I can adjust them. Seems to work, I'll know when I get it in the
car I guess.
Thanks.
--
Trevor Boicey
Ottawa, Canada
tboicey@brit.ca
http://www.brit.ca/~tboicey/
|